Foxconn 865M06-G-6EKS - Manual (Page 39)

Chapter 2 Installation Instructions
31
865M06 Series User Manual
S-ATA Connectors: CN21, CN22
The S-ATA header is used to connect the S-ATA device to the motherboard. These
connectors support the thin Serial ATA cables for primary internal storage devices.
The current Serial ATA interface allows up to 150MB/s data transfer rate, faster
than the standard parallel ATA with 133MB/s (Ultra ATA/133).
Audio Interface: F_AUDIO
The audio interface provides two kinds of audio output choices: the Front Audio,
the Rear Audio. Their priority is sequenced from high to low (Front Audio to Rear
Audio). If headphones are plugged into the front panel of the chassis (using the
Front Audio), then the Line-out (Rear Audio) on the rear panel will not work. If you
do not want to use the Front Audio, pin 5 and 6, pin9 and 10 must be shorted, and
then the signal will be sent to the rear audio port.
F_AUDIO
MIC_IN MIC_GND
MIC_PWR +5VA
AUD_OUT-R AUD_RET-R
NA Empty
AUD_OUT-L AUD_RET-L
1 2
9 10
SATA _1/SATA _2
GND GND GND
RX+
RX-
TX+
TX-