Denso BHT-100Q - Manual (Page 71)

55
Chapter 2. Getting Started the BHT and System Mode
[4.1] Setting an execution program
Selecting "1: EXEC PROGRAM" on the SET SYS-
TEM menu calls up the screen shown at left.
Highlighted is the current setting.
Use the M1 and M2 keys to move the cursor to a
desired execution program to be run when the
power is applied, and then press the ENT key.
To return to the SET SYSTEM menu, press the C
key.
If no program files are stored in the memories, the
screen shown at left will appear.
To return to the SET SYSTEM menu, press the C
key.