Denso BHT-100Q - Manual (Page 7)

v
WARNING
Handling the battery cartridge
• Never disassemble or heat the battery
cartridge, nor put it into fire or water;
doing so could cause battery-rupture or
leakage of battery fluid, resulting in a
fire or bodily injury.
• Do not carry or store the battery car-
tridge together with metallic ball-point
pens, necklaces, coins, hairpins, etc.
Doing so could short-circuit the termi-
nal pins, causing the batteries to rup-
ture or the battery fluid to leak, result-
ing in a fire or bodily injury.
• Avoid dropping the battery cartridge or letting it undergo any shock
or impact.
Doing so could cause the batteries to break, generate heat, rupture or
burn.
• Never charge the rechargeable battery cartridge where any inflam-
mable gases may be emitted; doing so could cause fire.
Handling the BHT
• The BHT-100B uses a laser light for indicating the scanning range.
The intensity of the laser light might be too low to inflict bodily injury.
However, do not look into the laser beam.
The BHT-100B complies with Laser Safety Standard, Class II of 21 CFR
Chapter 1, Subchapter J.
The BHT-100B does not mount beam attenuator and laser radiation
emission indicator required by this standard. Instead, the software-
controlled trigger switches (see Section 2.2 "Components and Func-
tions") function as them because the laser light is not enabled without
the trigger switches pressed.
Never
put me
into fire!
Do not
short-
circuit me!
Undedicated
• Only use the dedicated charger (CU-
7001, C-700 or C-750) for charging the
rechargeable battery cartridge.
Using a different type of charger could
cause battery-rupture or leakage of bat-
tery fluid and result in a fire, bodily in-
jury, or serious damage to property.
Charge only
with the
dedicated
device.