Formax 6200 (600) Series - Manual (Page 42)

2.3 Insert path
Main path of inserts in feeders D and F
In case of a jam occurring in the main path of inserts in feeders D and F, follow the procedure below:
- Open fully the machine and then open the right-hand and the lefthand doors,
- Rotate the two knurled knobs 1 and 2 until the jammed insert is visible and remove it.
- If it is not possible to move forward the insert by rotating the knurled knobs, unlock the insert path by
turning the control 3 to the left. This will lower the platform,
- Remove the jammed insert,
- Close the machine and the two doors.
Note: Set the machine to its initial position (vertical) in order to avoid any further jam.
Note: If the insert cannot be reached, remove it from the upper path of feeders D or F (see
following paragraphs).
36