Formax 6200 (600) Series - Manual (Page 22)

If the modification meets your requirements, you can store the job either under the same number and
the same name as the initial job (if it is not protected; see supervisor mode) or under a different
number and/or name. No job can be performed if it is not stored.
2.1.6 Creation of a job
From the MAIN MENU, select "CREATE A JOB" and confirm by pressing the "OK" key.
Using the selection keys and "OK" key, select the descriptions displayed that match your application.
You will then be able to create a new job. At every step of the creation, you may get back by pressing
the "ESC" key, in order to make different selections.
At the end of the creation procedure run a test cycle to verify the application.
If the job meets your requirements, you can store it under the number and name you wish (apart from
the protected job numbers). No job can be performed if it is not stored.
2.1.7 Counters
The machine is equipped with the below counters:
- A counter of cycles per job. Counters can be reset either individually or all at once.
- A counter totaling the counters of cycles per job.
- A “cycle” counter totaling all the machine cycles.
2.1.8 Countdown counter (Batch Counting)
The machine can operate by counting down the documents, provided that the number of documents
to be processed has been previously set.
To select the quantity, use keys ↓ and ↑ and confirm by pressing "OK".
The “Unlimited Quantity” selection is designed for continuous operation.
When the countdown counter is selected, the countdown value is displayed on the “CURRENT
CYCLE” screen.
16