Formax 6200 (600) Series User Manual

Page 21

When the "?" key is pressed, a short description of the job is displayed:

After verification press the "ESC" key to get back to the previous menu.

For a more detailed check of the job content, select "MODIFY THE JOB" and confirm by pressing the
"OK" key.

Thus, you will go through the job definition by pressing on the "OK" key after each screen, until the
END OF PROGRAMMMING MENU, which offers the job storage selection. At any time, you may get
back to the previous screen, by pressing on the "ESC" key up to the starting menu of the selected
job.

2.1.4 Starting the job

Load the appropriate feeders with your documents and follow the directions displayed on the control
panel screen.

2.1.5 Modification of a job

Select "MODIFY THE JOB" and confirm by pressing the "OK" key.

In order to modify the job, select the descriptions displayed that match your application. To do so,
use the selection keys and confirm by pressing the "OK" key.
At every step of the modification procedure, you can get back by pressing the "ESC", in order to
make different selections.

At the end of the modification procedure, run a test cycle to verify the application.