Formax 6200 (600) Series User Manual

Page 18

1.4.3 Maintenance

See section C, "Cleaning Procedure".

1.4.4 Servicing mode (access)

This mode cannot be accessed by the user, it is designed for the technical services.

1.4.5 Supervisor mode

Commonly used, the supervisor mode gives access to the advanced settings of the machine, as
described below:

- Inserting position,
- Flap moistening length,
- Aligning of documents from feeders B and C,
- Activation of double document detecting function.

This mode is protected by an access code that your servicing agent may provide you.

In order to access the supervisor mode, turn the machine off, then turn it on after a few
seconds. When the countdown appears under the machine diagram, press the "ESC" key .
Select “SUPERVISOR” and confirm the selection by pressing the "OK" key. Enter the
supervisor code and confirm by pressing the "OK" key.

2. OPERATION

To operate this machine you must properly input your application data:

- What documents and what envelopes do you want to use

- How do you want to combine and fold your documents

This data is stored in the machine as “jobs” corresponding to each use. Fill the feeder(s) according to
the job to be carried out (see § “Document feeding”).

You may use the machine as follows:

- In the “user mode”, which provides a wide range of basic functionalities or
- In the “supervisor mode” (or expert user) offering a wider range of functionalities.

You will be supported and guided at every step of the operation, via both an on-line assistance and
icons displayed on the control screen.