Formax 6200 (600) Series - Manual (Page 37)

Display / symptom Possible cause Solution
Significant document shift
(feeders B and C). Poor adjustment of the
documents (feeders B and C). See section B "Adjustment of
the document alignment".
The jam clearing doors of the
feeders are not properly closed. Close the doors properly. See
section C "Jam clearing".
The documents are not up to
the specifications or are
out of shape. See section C
"Specifications" and section B
"Document feeding". If required,
straighten manually the
document shape.
The rollers of feeders B and C
are dirty. See section C
“Cleaning of the rollers”.
The letters are left unsealed or
are not properly sealed. The moistening tank is empty. See section B
"Filling the tank".
The documents, inserts or
envelopes are not up to the
specifications (too many
sheets). See section C "Specifications".
The folds are not up
to requirements. See section B "Adjustment of
the folds" and "Jobcheck".
The moistening area is too
small. See section B "Length of flap
moistening".
The document is not properly
inserted. See symptom "Jam in the
inserting area".
The letter content is damp. Moistening area too wide See section B "Length of the
flap moistening".
The exit roller is wet. Wipe the exit roller (see section
C "Cleaning of the rollers").
Folding significantly
askew. Rollers of feeders B, C, D, E, F
or folding rollers are dirty. See section C
"Cleaning of the rollers".
The operating rate gets slower
or irregular. The guides are not properly
adjusted. See section B "Document
feeding".
Documents, inserts or
envelopes not up to
specifications or out of shape. See section C "Specifications".
If required, straighten manually
the document (envelope) shape.
31