Flowserve VTP Wet Pit - Manual (Page 67)

VERTICAL TURBINE PUMPS (VTPS) CENTRIFUGAL PUMPS ENGLISH 71569224 – 10-13
Page 67 of 76 flowserve.com
Parts list- Column and bowl assembly 8.3.2.1
Ref no. Description
2 IMPELLER
6 SHAFT-PUMP
8 RING-WEAR-IMPELLER
26 SCREW-CAP SOCKET HEAD
32 KEY-STRAIGHT
39 BEARING-SLEEVE-LINESHAFT
55 BELL-SUCTION
309 CASE-DISCHARGE
310 BOWL
312 RING-THRUST-SPLIT-IMPELLER
312* RING-THRUST-SPLIT-COUPLING
315 BARREL
319* RING-WEAR-BOWL
322 BEARING-SLEEVE-BOWL
323 BEARING-SLEEVE-BELL
326 STUD-THREADED
327 NUT-HEX
354 STUD-THREADED
355 NUT-HEX
426 SCREW-CAP-HEX
HEAD
428 PIN-ROLL
429 PIN-ROLL
430 O-RING
491 ASSEMBLY,
BOWL
492 ASSEMBLY, WEARING RING
493 ASSEMBLY, SUCTION BELL & WEAR RING
General Arrangement Drawing 8.4
The typical general arrangement drawing and any
specific drawings required by the contract will be sent
to the Purchaser separately unless the contract
specifically calls for these to be included into the User
Instructions. If these drawings are supplied
separately, the purchaser should retain those with the
User Instructions.
9 CERTIFICATION
Certificates determined from the Contract
requirements are provided with these instructions
where applicable. Examples are certificates for CE
marking and ATEX markings etc. If required, copies
of other certificates sent separately to the Purchaser
to be retained along with these User instructions.
10 OTHER RELEVANT
DOCUMENTATION AND MANUALS
Supplementary User Instructions 10.1
Supplementary instructions determined from the
contract requirements for inclusion into user
Instructions such as for a driver, instrumentation,
controller, sub-driver, seals, sealant system,
mounting component etc are included in the Data
Book. If further copies of these are required they
should be obtained from the supplier for retention
with these user instructions.
Where any pre-printed set of user instructions are
used, and satisfactory quality can be maintained only
by avoiding copying these, they are included at the
end of these user instructions such as within a
standard clear polymer software protection envelope.
Change Notes 10.2
If any changes, agreed with Flowserve Pump
Division, are made to the product after its supply, a
record of the details should be maintained with these
User Instructions.
.