Fieldpiece HG3 - Wireless HVAC Guide System Analyzer - Manual (Page 31)

www.fieldpiece.com www.fieldpiece.com www.fieldpiece.com www.fieldpiece.com www.fieldpiece.com www.fieldpiece.com www.fieldpiece.com www.fieldpiece.com www.fieldpiece.com www.fieldpiece.com www.fieldpiece.com
6 0 6 1
Setup Switch Position
Com with PC
Highlight Com with PC and press enter to upload and download tests to
and from a PC. See HVAC Guide Software Manual for detailed information.
Memory Management
From the Setup Switch Position you can delete a single test, entire cus-
tomer file, Grant info, data logs or all data. You can also check how much
memory is left using the Check Memory Status.
Setup switch position display.
Power Savings
Sleep Mode Set the HG3 to go into sleep mode after a desired amount of
time. Sleep mode turns off the display while leaving all other functions
running to save battery life. Press any button to come out of Sleep mode.
Default for sleep mode is 15 Minutes.
Auto Power Off Turn on Auto Power Off to save battery life. This is
useful if the HG3 gets accidently left on. Auto power off is automatically
disabled during data logging tests. You can set the time for Auto Power
Off. Default for Auto Power off is 30 minutes.
Version (about)
You can check the version of your Firmware by highlighting
Version(about) and pressing Enter. Keep your Firmware up to date by down-
loading the latest version from www.fieldpiece.com/downloads.
Time/ Time Setup
The internal clock is used to time stamp each saved test. The time can-
not be altered once data is taken. The time is shown at the bottom of most
INPUT FORMs.
• Rotate the dial to the SETUP.
• Scroll to Time Setup and Press ENTER.
• Press Enter to Change the time.
• LEFT and RIGHT arrows cycle through month, day, year,
military clock, and minutes.
• UP and DOWN arrows adjusts.
• Press ENTER to set time.
• Press INPUT to get you back to the main SETUP screen.