Fieldpiece HG3 - Wireless HVAC Guide System Analyzer - Manual (Page 11)

www.fieldpiece.com www.fieldpiece.com www.fieldpiece.com www.fieldpiece.com www.fieldpiece.com www.fieldpiece.com www.fieldpiece.com www.fieldpiece.com www.fieldpiece.com www.fieldpiece.com www.fieldpiece.com
2 0 2 1
1.3 Target Evap Exit Temp OUTPUT FORM
Outputs
Target Evap Exit DB Temp (Target Evaporator Exit Dry Bulb Tem-
perature) The target air temperature exiting the evaporator based on the
measured Return Air Wet Bulb and Dry Bulb. If charge and airflow are
adjusted properly, the Actual Evap Exit Temp should be close to the Tar-
get Evap Exit DB Temp.
Actual Evap Exit DB Temp (Actual Evaporator Exit Dry Bulb Tem-
perature) The measured air temperature leaving the evaporator. This is
the same as Out of Evap Supply Dry Bulb (See page 18).
Fan Press
(Fan Pressure) The pressure difference between the supply ple-
num pressure and the return plenum pressure.
Suggested Actions Suggested actions are displayed to correct the prob-
lem. Use the down arrow to scroll down the OUTPUT FORM.
See Sec
(See Section) The section numbers at the end of the OUTPUT
FORM refer to the sections in this manual with more detailed informa-
tion about each test.
Target Evap Exit Temp OUTPUT FORM.
Target Evap Exit Temp OUTPUT FORM continued from above.
Compare the Target to the
Actual Evap Exit Temp.
The OUTPUT FORM displays
the results of the test.
Use suggested actions to
fix the problem. Scroll
down to see more.
Continued from above. Use
the Up/Down Arrows to
scroll through the OUTPUT
FORM to see all suggested
actions.