Epiphan DVI2USB 3.0 - Manual (Page 29)

Windows Capture Application
24
DVI2USB 3.0 User Guide
have followed the installation and connection instructions described above. To perform
the following procedures you should have:
 video signal source
 video capture workstation running Windows; connected to a DVI2USB 3.0.
 DVI2USB 3.0 drivers and application installed on the video capture
workstation.
9.1 Start the Windows Capture Application
To start the application, from the Windows Start menu select Start > Epiphan Capture
Tool. The application starts up and looks for the DVI2USB 3.0 frame grabber
connected to your PC.
If the DVI2USB 3.0 is operating, the capture application should find it and the image
being captured by the DVI2USB 3.0 should appear on the application display.
If the DVI2USB 3.0 device is not capturing images, the application displays No signal.
As the application starts, the following messages may appear:
 Capture device not found as the application attempts to connect with
DVI2USB 3.0 device.
 Detecting Video Mode as the application connects to a device and then
determines the video mode of the device.
 Tuning Capture Parameters as the application synchronizes and tunes
capture settings and image adjustments.
 No Signal Detected if the application connects to the DVI2USB 3.0 that is not
connected to an active video source.
If the application successfully connects to and synchronizes with the DVI2USB 3.0
device, it begins displaying captured images.