DNF Controls UABS-I Installation_Manual - Manual (Page 30)

2 2 9 9 of 29 Flex Control Network ® UABS-I Installation Manual
2) Click on the “Edit Channel Assignment Table” link at the bottom of the
page. The Edit Channel Assignment Table will be displayed.
3) On Local Channel #1, click in the Remote IP address field and enter
the DC20’s IP address.
4) Click on the Remote Channel drop down arrow and select “1”.
5) On Local Channel #2, click in the Remote IP address field and enter
the DC20’s IP address.
6) Click on the Remote Channel drop down arrow and select “2”.
7) If DC20 channels #3 and 4 are used, assigned them to any of the
other Local Channels.
8) Click on “Save” to save the entered data.
OR
Click on “Back” to exit without saving.
I. Additional Setups
No additional setups are required in “System Maintenance” for normal
operation.