DNF Controls UABS-I Installation_Manual - Manual (Page 15)

Flex Control Network ® UABS-I Installation Manual 1 1 4 4 of 14
A. Serial Protocol Assignment
1) Click on “Edit Protocol Assignment Table”. An editable version of the
table will be displayed.
2) On Channel #1:
a) Enter a channel label (up to 20 characters) for the Master Control
channel.
b) select “vdcp” from the Currently Licensed Control Protocol drop
down menu.
3) On Channel #2:
a) Enter a channel label (up to 20 characters) for the Clip Review
channel.
b) select “vdcp” from the Currently Licensed Control Protocol drop
down menu.
4) On Channels #3 and #4, enter a channel label.
5) On Channels #3 and #4, select the proper control protocol, for the
device under control.
6) Click on “SAVE” to save the entered values
OR
Click on “BACK” to exit without saving.