DNF Controls UABS-I Installation_Manual - Manual (Page 18)

1 1 7 7 of 17 Flex Control Network ® UABS-I Installation Manual
C. PHYSICAL SERIAL (PHY) PORT CONFIGURATION
1) Click on the “Protocol Assignment” link at the top of the page. The
Protocol Assignment Table will be displayed.
2) Click on “Edit” field under the "PHY Configuration". An edit widow will
be displayed.
3) Click on the drop down arrow under “Baud Rate” and chose “38400”.
4) Click on the drop down arrow under "Stop Bit" and chose “1”.
5) Click on the drop down arrow under "Parity" field and chose “ODD”.
6) Click on the drop down arrow under "Char Size" field and chose “8”.
7) Click on drop down arrow field under the "Operation Mode" field and
chose "CONTROLLER". (If the video server port is configured as a
controller port, then select "DEVICE".)
8) Click on “SAVE” to save the entered values
OR
Click on “BACK” to exit without saving entered values.