DNF Controls UABS-I Installation_Manual - Manual (Page 14)

1 1 3 3 of 13 Flex Control Network ® UABS-I Installation Manual
6. DC20 SERIAL CHANNEL SETUP
Serial Channel Setup is required after initial installation. This step may be
performed at any other time, as required.
Serial Channel Setup is performed using a computer running an off-the-shelf
web browser such as “Microsoft Internet Explorer” or “Netscape”. Connect
the CAT5 cable from the computer to the same Ethernet hub that the DC20
Device Controller is connected to.
1) After launching the web browser, enter the IP address of the DC20 to
be setup. The DC20 Home Page will be displayed.
2) Click on the “Protocol Assignment” link at the top of the page. The
Protocol Assignment Table will be displayed.