DNF Controls DC20 - Manual (Page 4)

Flex Control Network ® , DC20 / DC21 User Manual Page 4
1. Getting Started
A. Installation
Install the DC20 Device Controller per instructions in the
INSTALLATION and CONFIGURATION sections. This step is required
only after initial installation.
This step will accomplish the following:
a) Physically install and wire the DC20.
b) Enter the IP, Subnet, and Gateway addresses and select
the desired Ethernet speed.
B. Configuration
Configure the DC20 per instructions in the SETUP section.
This step is required after initial installation. This step may be
performed at any time, as required.
This step will accomplish the following:
a) Set user selected password.
b) Set the system label to uniquely identify this DC20 Device
Controller.