DNF Controls DC20 - Manual (Page 14)

Flex Control Network ® , DC20 / DC21 User Manual Page 14
2) For each channel, enter a channel identifier (up to 20
characters) in the “Channel Label” box.
3) For each channel, select from the Licensed Control Protocol drop
down menu.
4) Click on “SAVE” to save the entered values
OR
Click on “BACK” to exit without saving entered values.
B. Serial Device Configuration
1) Click on the “Protocol Assignment” link at the top of the page.
The Protocol Assignment Table will be displayed.
2) Click on “Edit” field under the "Device Configuration". An edit
widow will be displayed.
3) Click on drop down arrow field under the "Control Functions"
field and chose the control functionality (depending on licensed
protocols).
4) Enter the "Device Latency" (the amount of time the server takes
to react to commands, typically 1 to 2 seconds).
5) VDCP protocol requires that a channel number be assigned.
This is the channel number assigned by the server.
6) Check the "Extended IDs" box if the server allows greater than
8 character clip names.
7) Enter the "TSO" (tape speed override) value, 25% Maximum.
8) Click on “SAVE” to save the entered values