DNF Controls 2034CL-TO - Manual (Page 9)

2034CL-TO, Pinnacle Thunder Protocol 9
9. RECALL ON THE SHOTBOX
Select the desired Cue Point by pressing the BANK [0] – [9] and then the ShotKey.
10. PLAY MODES
There are now three play modes available:
‰ NORMAL PLAY [LOOP ENABLE] = off [PTL] = off
‰ LOOP PLAY [LOOP ENABLE] = on [PTL] = off
‰ PLAY-TO-LOOP [LOOP ENABLE] = on [PTL] = on
NOTE: All transport modes, other than PLAY, are disabled when [LOOP ENABLE] is ON.
a. NORMAL PLAY
This mode is active when [LOOP ENABLE] and [PTL] are not selected.
The clip will play from its present location to the OUT point and stop.
If the clip is beyond the OUT point when play is pressed, it will play to the END of the
clip.
b. LOOP PLAY
This mode is active when [LOOP ENABLE] is selected and [PTL] is not selected.
The clip will play in an infinite loop between the IN and OUT points.
If the clip is outside the LOOP when [PLAY] is pressed it will CUE to the IN point and
then start playing.
c. PLAY-TO-LOOP
Select [PTL] to activate this mode. ([LOOP ENABLE] is automatically enabled.)
The clip will play from where it is parked (usually at the start) to the OUT point, then
CUE to the IN point and play in an infinite loop between the IN and OUT points.
If the clip is beyond the OUT point of the LOOP when [PLAY] is pressed, it will first
CUE to the START of the clip and then go into PLAY-TO-LOOP.
NOTE: If no IN point is marked, the default IN point is the START of the clip, and if no
OUT is marked, the default OUT is the END of the clip.