DNF Controls 2034CL-TO - Manual (Page 8)

2034CL-TO, Pinnacle Thunder Protocol 8
6. LEARN ON THE ST300
a.
Select a VTR by pressing VTR [1], VTR [2], VTR [3] or VTR [4].
b.
LOAD a Clip. If LEARNING a Gang, load all clips and set the Gang.
c.
Select the desired Cue Point by pressing [NEXT CUE], [LAST CUE], or by manually
entering the Cue Point using the numeric keypad.
The selected Cue Point number is shown on the bottom line of the display.
d. Press [SHIFT] + [MARK] to initiate the LEARN.
The display will show:
e.
Press the VTR key desired: [1],[2],[3],[4].
f. Press
[MARK] and the ST300 will:
LEARN (save) the VTR Number (1,2,3,4), loaded CLIP ID and current IN/OUT time to
the selected Cue Point.
7. LEARN ON THE SHOTBOX
a. Press
[LEARN]. The LEARN indicator will turn on.
b.
Select the BANK [0] – [9] and then the desired Shotkey.
c.
The Learned CLIP ID will be displayed on the pressed key.
NOTE: This will overwrite what you have assigned to the key previously.
d. Press
[LEARN] to exit at any time.
NOTE: The [LEARN] key toggles LEARN mode on/off.
8. RECALL ON THE ST300
a. Select the desired Cue Point by pressing [NEXT CUE], [LAST CUE],
or by manually entering the Cue Point using the numeric keypad.
The selected Cue Point number is shown on the bottom line of the display.
b. Press
[LOAD] on the ST300.
The ST300 will automatically load the Learned clips on the Learned VTRs, cue the clips
to the Learned time, then set the Learned GANG mode.
Press VTR:
MARK-Lrn ESC-Cancel