DNF Controls 2034CL-TO - Manual (Page 13)

2034CL-TO, Pinnacle Thunder Protocol 13
b. VIEW THE IN (OUT) POINT
1)
When the IN (OUT) indicator is on, press [IN] ([OUT]) to view the existing IN
(OUT) Point.
2)
While viewing the IN (OUT) Point:
Press [MARK] to overwrite the saved time with the current time.
Press [RECUE] to search to the IN (OUT) point.
c. CLEAR THE IN (OUT) POINT
1)
Press and hold [DEL].
2)
Press and release [IN] ([OUT]). The IN (OUT) indicator will turn off.
d. ENTER PREROLL VALUE
1) Press
[MENU] and turn the Wheel until “Enter PREROLL:” is shown.
2)
Enter the desired preroll value using the ST300’s numeric keypad.
3) Press
[ENTER] to save the entered value.
OR
Press [ESC] to exit without saving.
e. EXECUTE CAPTURE FUNCTION
1) Press
VTR[2], VTR[3] or VTR[4] to select the source VTR.
2) Press
[SHIFT] + [RECORD].
The display will prompt you for a CLIP ID. A default CLIP ID will be shown.
3) Press
[LOAD] to accept the default CLIP ID.
OR
Use [NEXT CUE], [LAST CUE] and Wheel to edit the CLIP ID.
4) Press
[LOAD] to accept the CLIP ID.
The ST300 will create the new CLIP ID on the Video Server.
The Source VTR will preroll to the IN Point, then play.
At the Source VTR’s IN point, the RECORDER will go into record.
At the Source VTR’s OUT point, the RECORDER will stop record, post-roll for
2 seconds, then stop.
The Source VTR will search to the OUT point and stop. The OUT point will be
cleared.
The IN indicator will stay on. The OUT indicator will turn off.