DNF Controls 2034CL-TO - Manual (Page 12)

2034CL-TO, Pinnacle Thunder Protocol 12
Advanced Features . . .
14. CREATING A CLIP
a. Press
[CLIP LIST]. The CLIP LIST indicator will turn on.
The display will show “CREATE NEW CLIP.”
b. Press
[LOAD]. The display will show the default CLIP ID.
c. Press
[LOAD] to accept the default CLIP ID.
OR
Use [NEXT CUE], [LAST CUE] and Wheel to edit the CLIP ID.
Use the [NEXT CUE] and [LAST CUE] keys to position the cursor.
Turn the Wheel to select the desired letter.
OR
Enter a name with a maximum of 8 characters on the SHOTBOX keyboard.
NOTE: On the SHOTBOX, for numbers, use bank keys 0-9, with “0” being 10.
d. Press
[LOAD] on the ST300 or on the SHOTBOX to create the selected CLIP ID.
e.
If the selected CLIP ID already exists, a warning message will be displayed. To load the
existing clip, press [ENTER]. Press [ESC] to exit without loading the existing clip.
15. CAPTURE FUNCTION
The CAPTURE function allows source material from a VTR to be recorded into the Video Server.
A CLIP ID is also created.
VTR1 is always the Recorder (the Video Server).
Select VTR [2], [3] or [4], as the source VTR. Any RS422, SONY protocol compatible VTR can
be used.
Use the transport function keys to control the source VTR.
Each source VTR has its own set of IN and OUT points.
a. SET AN IN (OUT) POINT
1)
Shuttle to the location and press [IN] ([OUT]) to set the IN (OUT) Point.
The IN (OUT) indicator on the ST300 will turn on.
OR
Press [SHIFT] + [IN] ([OUT]) to manually enter a new IN time.
2)
Press [ENTER] to save the entered time.
OR
Press [ESC] to exit without saving.