DFI G7B330-BR User Manual

Page 49

Text mode
Original mode

Hardware Installation

Chassis Open Connector

The system board supports the chassis intrusion detection function.
Connect the chassis intrusion sensor cable from the chassis to J1.
Whenever a chassis component has been removed, the sensor
sends signal to J1 alerting you of a chassis intrusion event. To disable
this function, place a jumper cap over J1.

Hardware Monitor for Windows

Install the “Hardware Monitor for Windows” utility. By default, the
chassis intrusion detection function is disabled. When enabled, a
warning message will appear when the chassis is open. The utility can
also be configured so that a beeping alarm will sound when the
chassis is open. Refer to the “Hardware Monitor for Windows”
section in chapter 4 for more information.

1
2

Ground

Chassis signal

This manual is related to the following products:

G7B330-B rev. AE G7B330-B rev. B G7B630-B G7B630-N BL630-D BL630-DR BL600-D BL600-DR LT330-B BL330-B BL330-BR G7L331-B G7L331-B-L