Delta Dore 230 CPL DRIVER Installation - Manual (Page 5)

Associating Driver 230 with
a transmitter
On the DRIVER 230 CPL, you can associate a “PLC trans-
mitter” type device (GECPL1, GP4 CPL, TYPHONE 2 CPL,
etc.). Otherwise, confirm to move onto the next step
The unit displays “EMET” alternating with
“----”.
• To associate an energy manager type transmitter
(GECPL1, GP4 CPL, etc.)
Confirm on the transmitter (see the relevant
guide).
The display reads GE--.
Note: Press to cancel.
• To associate a PLC telephone remote control type trans-
mitter (TYPHONE 2 CPL)
Confirm on the transmitter (see the relevant
guide).
The display reads --TL.
Note: Press to
cancel.
If DRIVER 230 CPL is associated with 2
types of transmitter, the display reads GETL.
Press to confirm your choice and move
on to the next stage.
4
3
- 8 - - 9 -
Startup mode enables the PLC products to be combined
amongst themselves and the installation organisation to be
determined (transmitters, receivers, pilot wire type, load shed-
ding, etc.).
Note: You may only define one type of pilot wire for each zone.
Enter startup mode.
Turn the knob to .
Set the clock if necessary (see user guide)
or press to move onto the next step.
The unit displays PArA.
Determining the type of pilot wire
Press the and buttons simulta-
neously.
The unit displays FP4 (4-order pilot wire) or
FP6 (6 order pilot wire) for zone 1.
Press the
and buttons to determine
the type of pilot wire used, then press to
validate.
Repeat the operation for zones 2 and 3.
2
1
Starting up
Z2 Z3 Z1