Relay configuration for external applications – DC Power Technologies FS3 Version 3 - Technical Hardware Manual User Manual
Page 29

Page | 28
Relay Configuration for External Applications
The on-board relays fitted to the MPC controller allow control of
external devices such as lights, indicators or Auto Watering.
Jumpers for each relay allow setting of the default state, NO
(Normally Open) or NC (Normally Closed).
Relay Function
Notes
1
Charge
complete
BSI option must be enabled in
Controller Settings
2
Auto Watering
Auto Watering must be enabled in
Configuration tab
3
Charge Active
BSI option must be enabled in
Controller Settings
4
Alarm 1
Relay Alarm mode must be enabled in
Controller Settings
5
Alarm 2
Relay Alarm mode must be enabled in
Controller Settings
This manual is related to the following products: