DC Power Technologies FS3 Version 3 - Technical Hardware Manual - Manual (Page 19)

© 2014 Enatel Motive Power Ltd. Specifications subject to change without prior notice. Errors
exempt. Pictures may be representative, actual products may differ.
Charger Modules
The primary function of the charger modules is to rectify AC mains
into DC suitable for battery charging.
Module Types
There are four module types available depending on the input and
output requirements of the charger. The module variants are
detailed in the table below.
Low Voltage Output High Voltage Output
MP130 MP330 MP133 MP333
Supply
Phase
Single or 3
Phase
3 Phase only
Single or 3
Phase
3 Phase only
Input Voltage
Range 208 - 240 380 - 480 208 - 240 380 - 480
Output
Voltage
Range
25 - 65 70 - 143
Nominal
Battery
Voltages
24 / 36 / 48 72 / 80
Faceplate
Color
Yellow/Black Green Blue/Black Blue/Green
Charger
Compatibility FS3L
FS3L, FS5L,
FS9L
FS3H
FS3H, FS5H,
FS9H
Charger Module Front Panel
Charger modules have a front panel with three LEDs to indicate
their basic operating state. The charger front panel display and LED
indicators typically provide any charger status information, however
the charger module LEDs are useful for understanding and
troubleshooting charger issues.
The module front panel LED indicators are as follows:
RED AMBER GREEN
No Output Current Limit Charging