Fs5/9 – DC Power Technologies FS3 Version 3 - Technical Hardware Manual User Manual
Page 18
Page | 17
FS3
The optional FS3 mounting bracket allows the charger to be fixed to
a surface via the base, rear or left side.
The bracket can be mounted to an appropriate surface suitable for
the particular configuration of the charger.
An FS3 with three modules can weigh up to 21kg.
The charger incorporates two slots for locating the bracket and two
captured thumbscrews then secure the charger to the bracket.
FS5/9
The FS5/9 wall mounting bracket requires eight fasteners to secure
it to the supporting wall.
An FS9 with nine modules can weigh up to 90kg.
The charger can be positioned on and fixed to the bracket using M5
machine screws fastening into the charger base frame. The same
base mounting points may be used for a standard shelf, rack or
table-top. The base mounting measurements are as follows:
FS5-9 base screw spacing (mm, c-c): 333W x 275D