Fs3ln: ac input terminal block configuration, Single phase (mp13x modules), Three phase (mp33x and 3xmp13x modules) – DC Power Technologies FS3 Version 3 - Technical Hardware Manual User Manual
Page 26
Page | 25
FS3LN: AC Input Terminal Block Configuration
Standard FS3 models may be configured for single or three phase
input, depending on the type and number of charger modules
installed.
Single Phase (MP13x modules)
One 3-pole jumper and one 2-pole jumper required, fitted as shown.
Alternatively, two 2-pole jumpers may be used in place of the 3-
pole.
Three Phase (MP33x and 3xMP13x modules)
One 2-pole jumper required, fitted as shown:
FS3xJ: AC Input Terminal Block for Japan RST
Mains Supply
The RST configuration does not require jumpers. Input wiring colour
standards vary across Japan, therefore input wiring colours shown
are indication only. See below for important surge protection
information for MP130 and MP133 modules.
2-pole jumper location
3-pole jumper location
2-pole jumper location