Field wiring connections – DC Power Technologies FS3 Version 3 - Technical Hardware Manual User Manual
Page 24
Page | 23
*
In single phase mode the output power will reduce
to maintain maximum AC current draw.
** In three phase mode the adding of the third
charger module reduces the AC current draw to
achieve the same DC output as for two modules.
Field Wiring Connections
Field wiring connections should be made by a qualified
electrician.
A field wiring terminal strip on the input side of the AC Filter PCB
allows the connection of AC supply wiring to the unit.
Access into the frame should be gained through one of three
knockouts in the rear panel.
A minimum of 2.5mm² multi strand cable per connection
should be used and cable-tied to the strain relief mount
provided.
Wiring color should conform to standard practice for the
region of installation.
L1 L2 L3 Neutral Earth