Dataprobe RSS Series - Manual (Page 5)

V130816E.R1
RSS Series Page 5
2.3. Power Supply Indicators
The Chassis has two LED indicators that display the current status of two power supply sources. These are
designated PS-1 and PS-2. LED on Indicates the power supply source is connected.
PS-1 Internal Power Supply Module, or External Power Supply #1
PS-2 Internal Power Supply Module, or External Power Supply #2
2.4. A/B Card Status Indicators
Each A/B switch card has LED indicators that can be viewed from the front panel of each chassis. When an A/B
Switch is installed, the LEDs for that slot will be either A or B to indicate the status of the card. With no A/B Switch
installed, there will be no LEDs to view.
2.5. A/B Card Manual Toggle Switches
Each A/B switch card has al toggle switch for local control. The switches are accessed thru slots in the chassis
front panel. These are momentary switches. Move the toggle up to select the A position of the card or down for the
B position. With no card in a slot, there will be no toggle switch.
2.6. Gang Control Switches RSS-16
The RSS-16 chassis has three pushbutton switches for simultaneously controlling all A/B cards in the chassis. To
perform control, hold down the pushbutton marked Enable while pressing either the A or B pushbutton to operate
the switches.
In multi-chassis systems, the master chassis (containing the control card), these pushbuttons will operate all A/B
Cards in the system. In subsequent chassis, these pushbuttons will operate only the cards in that specific chassis.
2.7. Filler Panels
Blank Filler Panels - #1920128 Blank panels are available for covering and shielding unused card slots. Filler
panels are required for unused slots to meet UL and CE requirements.