beautypg.com

Command line interface, Factory defaults system chassis and rcu, Telnet – Dataprobe RSS Series User Manual

Page 12: Factory defaults, Serial port, Snmp, Initial connection

background image



V130816E.R1

RSS Series

Page 12

4.5.

Command Line Interface

The IPC-16-R is managed by a Command Line Interface (CLI) system via Telnet or Serial Port. The CLI uses a
username password challenge for security.

4.5.1. Factory defaults System Chassis and RCU

Username

admin

Password

admin

4.6.

Telnet

The system supports the Telnet communications protocol for management access. Optionally, the telnet server in
the IPC-16-Rcan be disabled with a CLI command.

Connect via Telnet client to the IP address of the IPC-16-R

4.6.1. Factory Defaults

RSS IP Address 192.168.1.254

4.7.

Serial Port

To login in to the IPC-16-Rusing the serial port, set the terminal to the baud rate and character format, then send a
Carriage Return .

Baud Rate Baud rate choices are 9600, 19200, 38400, 57600 and 115200 bits per second. Character format is
fixed at 8 Data Bits, No Parity, One Stop Bit. (8, N, 1)

4.7.1. Factory Defaults

9600, 8 Data Bits, No Parity, One Stop Bit (9600,8,N,1)

4.8.

SNMP

The IPC-16-R system is SNMP manageable. Up to four SNMP managers can be defined for the purpose of
delivering status Inform messages.

4.8.1. Factory Defaults

Read Community:

public

Read/Write Community:

private

Notification Timeout:

1 second

Notification Retry Count:

3

Lead Configuration Change:

0 seconds

4.9.

Command Line Interface

4.9.1. Initial connection

To establish a connection to the system chassis via the network, open a telnet client to the IP address of the
system. The session will begin upon connection.

To access the system chassis via the serial port, connect a suitable dumb terminal, or system running terminal
emulation to the serial port at the proper baud rate and character format. Send via the serial port to begin
the session.