Dataprobe iBoot-G2 Operation Manual User Manual
Dataprobe Equipment

Web Enabled
Power Switch
05/06/2014
1. Table of Contents
Table of Contents .................................... 1
Important Safety Instructions .................. 2
General Description ................................ 3
Hardware Installation .............................. 5
Initial Configuration ................................. 9
Web Browser Operation ........................ 11
Web Setup ............................................ 14
Command Line Interface ....................... 26
DxP Protocol ......................................... 34
Firmware Upgrades ............................... 34
Troubleshooting .................................... 35
Specifications ........................................ 36
Technical Support and Warranty .......... 37
Congratulations on purchasing the best network
controlled power switch available. The iBoot-G2+
provides you the ability to reboot crashed devices
with the click of a mouse. Be sure to read up on all
the features of the iBoot-G2+ Including:
Web Based setup and control with mobile browser
support.
Graceful Shutdown: attempt a soft shutdown or reboot
before cycling power.
Telnet setup and control
Event Scheduling: Set power actions on regular
intervals.
Expansion: Add low cost iBoot-EXP units for up to
three outlets controlled.
AutoPing: Automatic monitoring and action for failed
equipment.
I/O Control: Control or Monitor your own digital Inputs
and Outputs. Use inputs to control the AC outlet.
Management Utility: Easy Setup, Firmware upgrades
and Reset to Factory Default
Easy Software Integration: Use the DxP Protocol to
build your own custom applications.
New iBoot Cloud Service
– BETA – Control all your
iBoots from one web portal.
Document Outline
- 1. Table of Contents
- 2. Important Safety Instructions
- 3. General Description
- 4. Hardware Installation
- 5. Initial Configuration
- 6. Web Browser Operation
- 7. Web Setup
- 7.1. /Device Settings
- 7.2. Expansion Settings
- 7.3. /Network Settings
- Note: All of the TCP/IP Settings require a reboot of the iBoot-G2+, after clicking Save. A Reboot button will appear at the bottom of the page. The new settings will not take effect until the unit is rebooted. Reboot will not affect the power posit...
- 7.4. /Graceful Shutdown
- 7.5. AutoPing
- 7.6. /AutoPing Settings
- Note: All of the AutoPing Settings require a reboot of the iBoot-G2+, after clicking Save. A Reboot button will appear at the bottom of the page. The new settings will not take effect until the unit is rebooted. Reboot will not affect the power pos...
- 7.7. Heartbeat
- 7.8. Heartbeat Settings
- 7.9. Using Heartbeat Monitor
- 7.10. Using the Heartbeat Program
- 7.11. Event Scheduling
- 7.12. User Settings
- 8. iBoot Cloud Service – BETA
- 9. Command Line Interface
- 10. DxP Protocol
- 11. Firmware Upgrades
- 12. Troubleshooting
- 13. Specifications
- 14. Technical Support and Warranty