Daktronics KE-1010-7.6-RG - Manual (Page 8)

A module is the building block of the DakTicker display.
By placing modules side-by-side, a display of any length
can be designed and built. Individual modules can be
easily removed from the display, if required
. KE-1010
modules consist of an array of LED (light emitting diode)
pixels that are available in several matrix sizes. The
height options include 16-pixels high and 24-pixels high
as well as a twin ticker with two separate sections of 16
pixels high. Text can be configured into one large font or
two to three lines of smaller fonts, as shown in Figure 1.
Tickers are available in tri-color (red, green and amber) characters.
Figure 3: Front of 16 x 40 Module
1.2 Drawing References
Drawings may be referenced at the beginning of a section and also within the text. The
reference number consists of the last set of digits and the letter preceding them on the
drawing label (Figure 4). The drawing number is located in the lower-right corner of the
drawing. In the example below, the drawing would be referred to as Drawing B-206146.
Reference drawings are inserted or listed in Appendix A.
Figure 4: Drawing Label
1.3 Safety Precautions
• Read and understand these instructions before installing.
Introduction 2
• Be sure that the display is properly grounded.
• Disconnect power when servicing the display.
• Do not modify the display structure or attach any panels or coverings to
the display without the written consent of Daktronics.