Daktronics KE-1010-7.6-RG - Manual (Page 13)

Section 3: Power Installation
• Only a qualified individual should terminate power and signal cable at this Daktronics
display.
• All proposed changes must be approved by Daktronics engineering staff or the
warranty will be rendered null and void.
Reference Drawings:
Power Specs, GEN II, KE-101 * -16x *** , 24x *** , 2-16 *** .................................... Drawing A-234168
Shop Drawings........................................................................................................ in Appendix A
Schematics.............................................................................................................. in Appendix A
3.1 Power Requirements
The displays accept a universal input voltage of 100-240 VAC at 50-60 Hz. Refer to the
following table and the drawings referenced at the beginning of the section for voltage and
current requirements. The displays are sufficiently powered by a 100-240 VAC single-phase
outlet. Refer to Drawing A-234168 for the power specifications for individual DakTicker
display sizes.
No more than two additional sections may be powered from one powered section. Total
display length powered from one section is not to exceed 20 feet (6.1 M).
Figure 9: 16 and 24 High DakTickers Power Connection
Figure 10: 16 High Twin DakTicker Power Connection
Power Installation 7