Daktronics KE-1010-7.6-RG - Manual (Page 11)

Display Distance From Display Top To
Bottom Bracket Attachment Point
KE-1010-16x***-7.62 0’-10 ¼” (260 mm)
KE-1010-24x***-7.62 0’-13 ¼” (337 mm)
KE-1010-2-16x***-7.62 0’-17 ¼” (438 mm)
Mounting Multi-section Tickers
The echo sections are shipped without end caps. Remove the left outer end cap from the
master ticker and attach it to the left-most echo ticker (refer to Figure 8).
Figure 8: Master-Echo Installation Detail
1. Before attempting to connect the sections, check their mounted alignment in relation
to each other. If the alignment is off, then adjust the mounting clips on the back of
the tickers.
2. Hang each section according to the appropriate mounting directions.
3. Refer to Section 3 for routing power and Section 4 for signal installation to each
section.
4. Slide the sections together.
5. Slide the splice bar over the joint(s) between the displays.
6. Tighten the screws (provided in the splices) using a 3/16" hex wrench.
Mechanical Installation 5