Daktronics KE-1010-7.6-RG - Manual (Page 31)

Parts Replacement 25
Controller Address
The controller has a set of “DIP” switches or address switches, as shown in Figure 24. These
switches set the hardware address for the display system. When replacing a controller board,
be sure to set the DIP switches on the new controller to the same address configuration as the
controller which was removed.
Note: DIP Switches 1-4 are used for addressing, while switch 7 enables test mode. Switches 5,
6, and 8 are not used.
Switch
7
Switch
4
Switch
3
Switch
2
Switch
1
Address
Off Off Off Off Off 0
Off Off Off Off On 1
Off Off Off On Off 2
Off Off Off On On 3
Off Off On Off Off 4
… … … … … …
Off On On On Off 14
Off On On On On 15
On Off Off Off Off Test Mode
6.4 Daktronics Exchange and Repair & Return Program
To serve customers’ repair and maintenance needs, Daktronics offers both an Exchange
Program and a Repair & Return Program.
Exchange Program
Daktronics unique Exchange Program is a quick service for replacing key parts in need of
repair. If a part requires repair or replacement, Daktronics sends the customer a replacement,
and the customer sends the defective part to Daktronics. This decreases display downtime.
Before Contacting Daktronics
Insert important part numbers here:
____________________________________________________________
____________________________________________________________
____________________________________________________________
Fill in these numbers before calling Customer Service:
Display Serial Number: _____________________________________________
Display Model Number: _______KE-1010 DakTicker 7.62 mm____________
Contract Number: ___________________________________________________
Date Installed: ______________________________________________________
Location of Display: _________________________________________________
Daktronics Customer ID Number: _____________________________________