CREATOR DIG Series Full Digital conference system - Manual (Page 11)

CREATOR CHINA 2012-11 WWW.CREATOR1997.COM
4 User's Manual of DIG series Full Digital conference
CR-DIG5201 rear panel
the rear panel
① The host power switch
② POWER - Host power indicator
If system host is normally powered, this
indicator lights up.
③ The the LCD display
Display the menus, the button operations
and system parameters’ information.
④ The MENU - Menu to return button
Press this button to return to the upper menu.
——arrow buttons
Use this button to the left / right to select the
menu or adjust the parameter information.
ENTER——the OK button
Save the parameters or enter into the lower
menu to perform operations.
MODE——mode set
“MODE” button has “Easy Setup” function of
the microphone mode, press" MODE "button to
enter
the" microphone mode" setting
interface .you can view the current status or
re-set microphone mode, four kinds of modes are
available, the FIFO,NORMAL, FREE, APPLY.
Setup steps
Press the arrow buttons
to select a new
microphone mode, press "ENTER" button to be
OK, then press the "MENU" button to return
ACTIVE MICRO’S——Maximum speech
settings
“ACTIVE MICRO’S” button has a " maximum
speech" “Easy Setup” function, ， press thr
“ACTIVE MICRO’S ” to enter" the maximum
speech "set interface, you can view the current
status or re-set the maximum number of speakers.
Setup steps are the same with the the "MODE"
button settings.
BASS - bass adjustment
The BASS button has a bass adjustment
“Easy Setup” function. It is used to adjust the line
output and conference unit acoustic bass. press
"BASS" button to enter the bass settings interface,
you can view the current status or re-set the bass
parameters, Setup steps are the same with the
the "MODE" button settings.