Comtech EF Data Vipersat Circuit Scheduler v3.7.x ArrangeLink - Manual (Page 61)

Chapter 3 - Using ArrangeLink 3-19
Schedule Setup
Figure 3-19 Point-to-Point InBand Circuit, Point Two
When configuration of the Circuit Specific Options is completed, click on the
Continue button to proceed to the Advanced Switching tab.
Point-to-MultiPoint Out-of-Band
Although this Circuit Type appears as a selection, it is not supported in v3.7.2 of
the VMS.
Point-to-MultiPoint InBand
In figure 3-20, the Point-to-Multipoint InBand circuit type has been selected
using the Circuit Type radio button. Use the following procedure to select the
equipment to be used for this circuit during the scheduled event.
1. Select the Remote site to be used as the transmitter for the scheduled event
from the network tree view, as shown in the figure.