Comtech EF Data Vipersat Circuit Scheduler v3.7.x ArrangeLink - Manual (Page 57)

Chapter 3 - Using ArrangeLink 3-15
Schedule Setup
Figure 3-15 Schedule Setup, Circuit Specific Options Tab
The device selection boxes will change to accommodate the Circuit Type
selected using the InBand, Out-of-Band or UpStream Switch radio buttons
shown in figure 3-15.
Circuit Type
The type of circuit selected for an event will be chosen by the traffic type. The
following sections contain brief descriptions of each of the available circuit
types. The schedule information, once entered into ArrangeLink, is stored in a
data base on the hosting web server.
The current satellite network configuration is retrieved from the VMS and is
used whenever hardware and bandwidth resources are allocated for a scheduled
event.
ArrangeLink allows scheduling events using InBand circuits for:
• Point-to-Point
• Point-to-MultiPoint
• UpStream Switch
Note: Although non-Vipersat modems can be monitored by the VMS (via the
SNMP Modem Manager), Out-of-Band switching of these modems is not
supported in version 3.7.2. Do not attempt to select Circuit Types for
either Point-to-Point Out-of-Band or Point-to-Multipoint Out-of-Band.
NOTE