Comtech EF Data CMR-5910 Manual User Manual
Page 49

Digicast Media Router Serial IP (SIP): CMR-5910 (MG-SIP) & CMR-5920 (MR-SIP)
Revision A
Device Management via User Interfaces - CMR-5920 (MR-SIP)
MN/MDRTRIPDC.IOM
NOTE
Beginning with the Administrative Configuration page, for pages
featuring configurable parameters, changes will not be accepted
without a valid user name and password. A login dialog box is
available at the bottom of the page for this purpose.
The Administrative Configuration page (Figure 5-3) has the following configurable parameters:
User Name
The User Name is user configurable and is used for connecting to the unit via IP
management services.
The default User Name is
comtech
.
Password
The Password is user configurable and is used for authenticating a user when
connecting via IP management services. Note the password is case sensitive and
must be entered carefully. When the password is changed, the user will be
prompted to enter the password twice to verify it is correct.
The default Password is
comtech
.
System Contact
Contact information of the system administrator for support.
System Location
The location (physically) where the unit has been installed.
SNMP server IP Address
Defines the SNMP server that can connect to the unit.
Enable Telne
t
Enables Telnet application on the MR-SIP.
Login Required
To make any changes to the MR-SIP, a user name & password are required.
Update Firmware
Allows software/firmware changes to be made. User name & password is
required for security.
5-3