Cadac SAM - Manual (Page 9)

Installing the CADAC Sound Automation Manager 1-1
Revision SAM2005-2 Sound Automation Manager
4 ,QVWDOOLQJ#WKH#&$'$&#
6RXQG $XWRPDWLRQ#0DQDJHU
414 &RPSXWHU#UHTXLUHPHQWV
To run the Sound Automation Manager requires a computer with the minimum per-
formance and peripherals as listed below:
IBM PC compatible computer
Windows ® ‘98 (second edition), 2000, XP or XP Pro
Graphics card 1024 x 768 pixels, High Colour 16-bit or better
Ethernet interface 10Mbit/sec with 10base2 connector (BNC) 1
128 MB RAM
20 MB free hard disk space
PS/2 keyboard (older 5-pin DIN keyboard can be used with adapter) 2
PS/2 mouse or pointing device (9-pin’D’-serial devices cannot be used) 3
415 ,QVWDOOLQJ#IURP#&'0520
The Sound Automation Manager software is normally supplied on a CD-ROM. To
install SAM, place the CD in the CD-ROM drive on your computer. Depending on the
supplied version of SAM, the installation process may or may not start automatically.
If it does not, follow these steps to manually install the software:
■ ■ ■ ■ In the Windows Start menu, click on Run…. A dialog box opens, see fig 1-1 . In
the box Open, type D:\setup.exe and click OK. If your CD-drive has a different letter
assigned to it, substitute this letter for D.
The installation process starts and you will be guided through each step. Each set-
ting has a default option. Accept the default option unless a CADAC engineer or
other qualified person has instructed you otherwise.
1. The Seance box is supplied with 2 10base2 cables, 2 T-pieces and 4 terminators.
2. The Seance box interface can switch 1 keyboard, 1 mouse and 1 monitor between 2 com-
puters. The Seance box is fitted with PS2 connectors.
3. See 2.
FIG 1-1. The Run program dialog box