Cadac SAM - Manual (Page 55)

Opening and Saving shows 6-7
Revision SAM2005-2 Sound Automation Manager
91;15 &UHDWLQJ#/LQNV
Once you have established where the Console differs from the Show you can convert
or translate the original show data to make it suitable for the replacement faders. This
translation will be more or less complete depending on which type of fader/module is
the source and which type is the target.
To create a link we perform the following steps:
■ ■ ■ ■ Select one or more faders/modules in the Show configuration by clicking on the
coloured box (-es) with the left mouse button. Shift-clicking and Ctrl-clicking may be
used to form multiple selections.
■ ■ ■ ■ In the Console configuration, click on the fader/module to which you wish to
make the link. In the case of multiple selection you only need to select the first fader/
module, the rest are implied by the size of the group selected in the Show.
NOTE: The linked fader/module does not have to be the one in the same frame posi-
tion. Clicking the button labelled Make will create the links.
When all the required links have been created, the Bad Links and New Blanks
counters show zero.
When all links have been made, click the OK button. SAM will run through the cues
of the show being opened and change the data as required to accommodate the new
modules.
FIG 6-10. Selected faders, ready to make links.