Cadac F-Type - Manual (Page 51)

Input modules 3-3
Revision F2005-2 F-Type
61418 ,QSXW#5#3KDQWRP#3RZHU
The 48V switch connects the phantom power to the I/P line. This can be used to sup-
ply power to most makes of capacitor and electret microphones.
61419 ,QSXW#5#3)/
There are three PFL switches included in the module to allow the operator to instan-
taneously monitor the audio signal in the channel at three different points. There is a
separate PFL switch for each input and an ‘overall’ module PFL switch near the fader
section.Use this PFL switch to check the input 2 stage. Operation of this switch is
interlocking so that each new selection removes the previous PFL.
6141: ,QSXW#4#21
As for 3.1.1.
6141; ,QSXW#4#*DLQ
As for 3.1.2.
6141< ,QSXW#4#053G%#3DG
As for 3.1.3.
614143 ,QSXW#4#3KDVH#5HYHUVH
As for 3.1.4.
614144 ,QSXW#4#3KDQWRP#3RZHU
As for 3.1.5.
614145 ,QSXW#4#3)/
As for 3.1.6
614146 2VFLOODWRU#5RXWLQJ
This switch routes the oscillator to both input stages (pre-gain control).
614147 5RXWLQJ
These are locking switches for routing the input signal to any of the available sub-
groups. When the switch is selected, the associated LED illuminates.
614148 3DQ#2122))
Press this switch to activate the pan control.
614149 3DQ#FRQWURO
The pan control, when activated, pans the input signal between odd (L) and even (R)
subgroups. The panpot has a 0dB centre point with +4.5dB of gain when fully clock-
wise or counter-clockwise.