Cadac C-Type - Manual (Page 18)

2-4 Input channel module 7911
C-Type Revision C2005-2
514144 +)#4#FRQWURO
The Q-control varies the bandwidth of the boost/cut at the frequency chosen (Q is
only available at the default BELL response). A low Q-value gives a wide bandwidth.
This means that a relatively large range of frequencies, either side of the centre fre-
quency, have boost/cut applied. When the Q-value is high, the bandwidth is reduced
so that a much smaller range of frequencies have boost/cut applied.
514145 #+)#)UHTXHQF\/#%RRVW2&XW#FRQWURO
Dual ganged control allow you to choose the “centre” frequency at which the boost/
cut is applied and to define the amount of boost or cut applied to the high frequency
band.
2.1.12 HF Frequency, Boost/Cut control
2.1.15 MF Frequency, Boost/Cut control
2.1.17 LF Frequency, Boost/Cut control
2.1.21 HP Filter Frequency control
2.1.23 Aux Sends 1-4 level controls
2.1.25 Stereo foldback
2.1.27 Direct Output level
2.1.11 HF Q control
2.1.13 HF EQ Bell/Shelf switch
2.1.14 MF Q control
2.1.16 LF Q control
2.1.18 LF EQ Bell/Shelf switch
2.1.19 Equalizer In/Out
2.1.20 HP filter In/Out
2.1.22 Aux Sends Pre switches
2.1.24 Stereo foldback Pre switch
2.1.26 Direct O/P Pre switch
,QSXW#&KDQQHO#:<44#0#IURQW#SDQHO