Cadac C-Type User Manual
Page 11
Connecting the mixer systems
1-5
Revision C2005-2
C-Type
GND and “FRAME” terminals on each frame must be connected. For minimum
noise, the large diameter ‘frame-link’ cables (supplied with multi-frame consoles),
must be connected. Always make sure that ‘frame-link’ cable nuts are tightened
against the copper bar.
The 0v, GND and FRAME terminals are linked in the factory with a copper bar. This
bar should never be removed when the console is in normal use. Note that
Phantom
Power cannot be delivered from the input modules to the 48V bus if the copper bar is
missing, because the screened microphone input cables will not be terminated. It
may also cause damage to the motor faders.
*1'
)5$0(
39
FIG 1-6. 0V, GROUND and FRAME terminals.