BUG-O Systems Piper-Plus - Manual (Page 37)

37
10.2.5 True Speed – True Speed is the actual calculated speed of travel used for heat input
calculations. It calculates the actual travel speed depending on the weave mode,
using the weave speed, amplitude, dwells, and travel speed.
10.2.6 Dwell Stop Height – This function will ignore the Automatic Height Control during dwells.
This improves performance with pulse waveforms and solid wire.
10.2.7 STT ® Side Start/Stop – This function will cause the weaver to move to the side before striking
the arc. It will not move if the procedure is set for Straight Line Mode.
SECTION 10.2 TRAVEL TAB, CONT’D.