BUG-O Systems Piper-Plus - Manual (Page 21)

21
SECTION 4.1 RUN SCREEN - ADJUSTING PARAMETERS
Depending on the configuration, it may be possible to make adjustments to the machine’s welding
parameters. Adjustments can be made on both the pendant and the control box. These adjustments
are limited by the configuration. It is not possible to make adjustments beyond the set limits.
4.1.1 Using the Run screen – By pressing the left and right arrow keys on the keypad you can
select a parameter. Pressing the center “0” button on the keypad will cause the selected
parameter to become active. The active parameter will be underlined to show it is active.
Pressing left or right will adjust the parameters up or down if possible. Pressing the center
button again will allow the arrows to switch between parameters again. This allows a
manager or assistant to make adjustments within the bounds of the parameters, even if the
operator has a limited function pendant. These changes are shown on the display of the full
function pendant.
4.1.2 Using the pendant – Press the switches up and down to change the associated values.
Each press will adjust the parameters by a set amount. The first time a switch is pressed
it will display the current value on the pendant. The next time the switch is pressed it will
adjust the value up or down. You will not be able to make adjustments during the startup and
shutdown procedures (See SECTION 5.0).