BUG-O Systems Piper-Plus - Manual (Page 10)

10
SYSTEM OPERATION - The user interface is very intuitive and user friendly. Important information about
parameters and machine operation is displayed. An operator can have as much or as little interaction
with the interface as is required by the application. If the operator is not comfortable with the computer
based interface, it is only necessary to choose a pass and then control the machine from the pendant.
SECTION 2.0 – CONTROL BOX FRONT PANEL
Figure 2.0 – Control Box Front Panel
2.1 Display Screen – This screen provides all operation, program, and feedback data to the
operator.
2.2 Emergency Stop Button – This button, when pressed, provides immediate shutdown of the
system. All input power to the system is turned off and all motion and welding functions will
cease immediately.
2.3 Numerical Keypad – This keypad is used for all input of numerical data along with movement
from input box to input box within any given screen. Cancel, Delete and Enter functions are
also provided along the right side of the pad.
2.4 Mouse and Mouse Buttons – This “Joystick” style Mouse allows the operator to move the
cursor around the Display Screen. The buttons to the left and right allow selection of particular
input boxes.
2.5 Hot/Cold Switch – This switch determines if the welding function is active or inactive. If the
switch is positioned to the top, welding is active. If the switch is positioned to the bottom,
welding is inactive. When welding is inactive, all other functions will operate; except welding
contactor will not close. If this switch is changed during welding, an Emergency Stop will occur.
2.1
2.2
SECTION 2.0 CONTROL BOX FRONT PANEL
2.3
2.4
2.5