BUG-O Systems Piper-Plus - Manual (Page 19)

19
The run screen is displayed after clicking run. This screen displays information to the welder and
allows selection of passes that are stored in the chosen folder. Adjustments can be made on both the
pendant and the control box, if the pass configuration allows it.
Figure 4.0– Run Screen
4.1 Default – This area of the Run Screen displays the programmed settings for this pass. This
will display the original parameters loaded from the configuration file.
4.2 Running – This area of the Run Screen displays the actual settings that are running for this
pass. These reflect the changes the user has made and are the parameters that the machine
is using. The running values will be set to the default values when the pass is changed.
4.3 ArcLink ® – This box provides information regarding the status of the ArcLink ® communication
with the Lincoln Electric equipment. The box displays Green while connected and all functions
are correct. While connecting, the box will flash between black and green. This would occur
if the welding power source were to lose power while in the Run Mode. If this occurs, it is
necessary to wait until the box is Green before proceeding.
4.4 Volts Amps – When the system is idle, these boxes display the Volts and Amps that were
sensed at the end of the last weld. When the system is active, these boxes will grow very large
during the weld to make them easier to read.
4.1
4.2
4.3
4.4
4.5
4.6
4.7
4.8
4.9
4.10
4.11
4.12
SECTION 4.0 RUN SCREEN