BUG-O Systems Piper-Plus - Manual (Page 23)

23
5.1.I START – Starts the welding process. All other switches must be released. If the Hot/
Cold switch on the front of the control box is in the upper position (Hot) the machine
will weld. If the Hot/Cold switch is in the bottom position (Cold) it will dry run,
operating only the tractor drive and the weaver.
5.1.J STOP – Stops the machine normally, making it go through the crater process. If it
is pressed during startup or crater it will cause a quick stop. Pressing it two times
quickly will cause this to happen. If it is held while the machine is idle it will cause the
gas to purge.
5.1.K Quick stop – This will immediately turn off the welding arc and stop all the motors.
5.1.L Steering – Steers the torch left and right.
Figure 5.1
SECTION 5.0 PENDANT OPERATIONS, CONT’D.